Skip to main content
J. J. Keller Support Center

Tethered Solution

In lieu of using a Bluetooth connection between the mobile device and the ELD, a tethered solution of USB to Micro-USB can be used with the J. J. Keller® Semi-Rugged Compliance Tablet running KellerMobile version .204 and later (it is not available for other devices at this time).

 

Setup

Before the device can be installed in the truck, USB will need to be enabled in Encompass.  To do this, go to Setup in the drop down in the upper right hand corner.

Setup.png

Scroll down to the J. J. Keller Mobile Settings.

clipboard_edc656be097eab3f777b5beac5151efaf.png

Change the ELD Communication Mode to USB then Bluetooth. Click Save at the bottom of the page.

clipboard_e63784cfda19d9e380f72c8ec31c50e22.png

 

The next time drivers log in to KellerMobile and connects to the ELD via Bluetooth, they will be prompted for a firmware update.  Once that firmware update completes, they will then be able to connect to the ELD using a USB to Micro-USB tether.  Click here for a guide on how to connect the mobile device to the ELD.

 

Note: Changing the ELD Communication Mode to USB then Bluetooth is what triggers this firmware update to the drivers.  Since this is a company level wide setting, all drivers will be prompted for this update, even if they are not using the tethered solution.  Click here for information and tips regarding firmware updates.  The minimum firmware version required for the tethered solution is .147.

  • Was this article helpful?